Table of Contents
Advertisement
Additional
information
When the cooking
time ends, "End"
will show on the Display
and 4 beeps
will sound. (You can stop the
beeping
by opening
the door or by
touching
CANCEL.) "End" will remain
on the Display
and a beep
will sound
every 30 seconds
(to remind you
that food is left in the oven) until door
is opened
or CANCEL is touched.
The Display
will then show the time
of day.
Note: If the oven light and fan come
on when you touch START, the Start
lime has not been set correctly.
Open and close door, reprogram
AUTO START time, then touch START.
l
Additional
cycles
can be set when using AUTO START. Follow instructions
under the
proper
heading
(Auto Set TIME and TEMP Defrosting,
Cooking
in More Than One Cycle,
Cooking
with the Temperature
Probe, Using PAUSE, Using KEEP WARM) either before or
after you touch START.
l
You can change
times, or add cycles
at any time during the AUTO START cycle.
I, Touch the COOK Cycle
you wish to change
or add.
2. Touch numbers
for new time.
3. Touch COOK POWER, if desired.
4. Touch number
for new Cook Power, or touch COCK POWER again
if high is desired.
5. Touch START.
l
Opening
the door does not stop Auto Start operation.
CAUTION:
Use foods that will not go bad or spoil while waiting
for cooking
to start. Avoid using with milk or
eggs, cream
soups, cooked
meats, poultry or fish, or any item with baking
powder
or yeast.
Smoked
or frozen meats may be used; so can vegetables,
fruits and casserole-type
foods.
Any food that has to wait for cooking
to start should be very cold or frozen before it is put in the
oven. MOST UNFROZEN FOODS SHOULD NEVER STAND AT ROOM TEMPERATURE MORE THAN TWO
HOURS BEFORE COOKING
STARTS.
Other operating hints
1. To double check settings while the oven is running:
l
Touch the Command
Pad for the setting you want to check. The instruction
programmed
for that pad will show on the display
for 5 seconds.
Then the display
returns to showing
what the oven is doing.
2. To stop the oven while it is running:
l
Open the door. The oven will stop. Restart the oven by closing
the door and touching
START.
l
Touch CANCEL. All instructions
will be erased. You must touch in new instructions.
3. If you touch two instructions
into the same cycle, the second
set of instructions
will
cancel
the first
Advertisement
Table of Contents
