Care And Cleaning - Stadler Form Blender Five Black Edition Operating Instructions Manual

Operating
1. Place the jug on the motor base by locating it over the nodules on the
rubber dampening pad. The jug can be placed on the motor base in 4
different positions.
2. Place ingredients into the jug.
NOTE
Do not operate the blender when the jug is empty.
3. Place the lid firmly into position on the jug. Always ensure the measuring
cap is in place when processing except when the processing baton is
inserted through the opening in the lid.
NOTE
Always have the lid in position during processing.
4. Using the variable speed dial, select the desired processing speed from
1 – 5 and this will provide continuous processing until the dial is turned
anti-clockwise to the OFF position.
Due to the high processing speed of the Blender, processing times are
significantly reduced over those of standard blenders. Therefore we ad-
vise that until you are familiar with the speed of the Blender that you
keep a close watch on ingredients being processed.
TIP
Once processing has commenced, further ingredients can be added by re-
moving the measuring cap and pouring ingredients through the hole in the
lid.
NOTE:
Wait until blade comes to a complete stop before removing the lid or jug.
Blade Assembly
IMPORTANT:
Always ensure the blender is unplugged from the power outlet before fit-
ting or removing the blade assembly.
Always handle the blade assembly with caution, as the blades are extreme-
ly sharp. To assemble the blade assembly follow these steps and refer to
figure 2:
1. Position blade assembly into position in jug.
2. Whilst carefully holding the blade assembly in position place the locking
nut on the underside of the jug and tighten.
3. Using the spanner tighten and lock the blade assembly onto jug.
Processing Baton
Specially designed to assist during demanding processing tasks, the baton
allows you to safely push food down into the blades while the blender is
operating. See figure 3.
NOTE
When using the processing baton ensure the lid is firmly in place and the
measuring cap is removed.
Uses for the processing baton
• The processing baton can be used as a scraper or spatula to easily remove
thick mixtures such as batters and sauces from the jug.
• Use the processing baton to encourage hard to process ingredients into
the blades.
• Using the processing baton reduces blending times.

CARE AND CLEANING

NOTE
Ensure that the blender is unplugged from the power outlet prior to clean-
ing.
Washing
For best results, wash all blender components, excluding the base (motor
housing), in hot soapy water.
It is not recommended that any parts of the Blender be washed in the dish-
washer.
Quick clean
Half fill the blender with warm water and a small amount of detergent. Po-
sition the jug on the motor base and run the blender for 20-30 seconds.
Remove the jug, rinse it under running water and then allow to air dry.
Thorough cleaning
After completing the quick clean, should any ingredients remain, using the
spanner, remove the blade assembly and wash both the jug and blade as-
sembly in warm soapy water. Rinse well and dry.
Rinse the lid, ingredient cap and processing baton under running water and
wash with warm soapy water. Rinse well and dry.