Cisco 6800 Series Hardware Installation page 9

Hide thumbs Also See for 6800 Series:

Hardware Installation

Step 3

Install the plugs as described by the manufacturer.

Step 4

Install the screws through the bracket and into the plugs.

Step 5

Base station only: Connect the Ethernet cable to the device and route the cable through the slot in the device.

Step 6

Provide power to the device:

• Base station with PoE on the LAN: Additional power is not required.

• Base station without PoE: Plug the power adapter into the base station and route the cable through the

slot in the base station.

• Repeater: Plug the power adapter into the repeater and route the cable through the slot in the repeater.

Step 7

Align the slots in the bracket with the slots in the device and turn left until the device locks in place.

This graphic shows the alignment of the mounting bracket to the base station. The back of the repeater is

similar to the base station.

Mount the Base Station or Repeater on the Ceiling

Hardware Installation

Table of Contents