Table of Contents
Advertisement
The 2-position DIP switch (SW2) is used to configure for production test only. For normal use this
switch state should be set to "ON".
S5U13709P00C100
SW2-[2:1]
Configuration
SW2-[1]
SW2-[2]
= default setting
3.2 Configuration Jumpers
The S5U13709P00C100 Evaluation Board includes the following 2-pin, 3-pin and 8-pin jumper
blocks which are used to control function and for power consumption measurement. For jumper
locations on the evaluation board, see Figure 3-2: "Configuration Jumper Location"
Figure 3-2: Configuration Jumper Location
8
EPSON
Table 3-1b: Summary of Configuration Options
S1D13709
Pin
CORECE
PLLCE
S5U13709P00C100 Evaluation Board User Manual Rev. 1.00
S5U13709 Evaluation Board User Manual
Configuration State
1 (ON)
Normal use
Normal use
0 (OFF)
Not use
Not use
Advertisement
Table of Contents
