Work Piece; Shortening Of The Work Piece On A Circular Saw Before Cutting - Hoffmann MORSO Operating Manual

Fig. 1
Fig. 2
Instructions Manual
MORSØ
Notch Cutting Machine
Model NF

WORK PIECE

Shortening of work piece on a circular saw
before cutting
Before the cutting of the work piece it must be
shortened in the correct length on a circular saw.
It is very important that the saw blade is exactly
adjusted in 90° proportional to the machine table
(see fig. 1). The blade must also be exactly
adjusted in 90° proportional to the fence (see fig.
2).
If this adjustment is not correct on there will be a
gap in the finished joints.
B-1