Adjustment Of Cock-Bead Stops - Hoffmann MORSO Operating Manual

BEWARE OF THE
EXTREME SHARP
KNIVES
Instructions Manual
MORSØ
Notch Cutting Machine
Model NF
OPERATING INSTRUCTIONS F-2
Adjustment of the cock-bead stops
The cock-bead stops (1) are adjusted as follows:
1. Loosen the Allen screws on the cock-bead
stops (1) and move these to rear of the sliding
guide.
2. Using a test piece (2) make a notch cut into
the cock-bead. This cut must be the same
depth as the cock-bead. The overall width
must be equal to the width of the centre cross-
rail. When you are satisfied the two sizes are
equal, we can now position the cock-bead
stops (1).
3. Press the foot-pedal down and hold it in this
position. By operating the hand lever, bring the
knife block (3) forward into the previously cut
notch. Position the cock-bead stops (1)
against the cock-bead and lock them in place
using the Allen screws. When these stops are
fixed in position the knife block (3) can only cut
into the cock-bead as far as this setting. The
notch cut depth is then referenced from the
face of the cock-bead. The width of stile can
vary without changing this setting.
4. Check the alignment of the two cock-bead
stops (1) using a straight edge. By bringing the
knife block (3) forward, check that they are
level and true with the fence.
5. Lock the second Allen screws on the cock-
bead stops (1).
6. This setting will allow you to make regularly
accurate notch cuts in the stiles. These stops
will need no further adjustment unless the size
of the cock-bead changes.