Adjustment Of Height Stop - Hoffmann MORSO Operating Manual

BEWARE OF THE
EXTREME SHARP
KNIVES
Instructions Manual
MORSØ
Notch Cutting Machine
Model NF
OPERATING INSTRUCTIONS F-5

Adjustment of Height Stop

The height stop (1) is used for adjustment of the
knife block (2) to a suitable height compared to
the moulding to be cut.
In this way you avoid unnecessary high foot
movements.
The moulding is placed on the table (the knife
block must be in the rear position, as shown on
the picture). The knife block (2) is moved forward
to the front position by means of handle (3).
With the foot pedal (4) the knife block (2) is moved
down to the height required, yet min. 20 mm
above the moulding.
The height stop (1) is loosened the spanner.
Fasten the height stop against the foot pedal
tipper (5).
The height stop is also used for locking the knife
block in the bottom position when the machine is
not used.