Adjustment Of Springs - Hoffmann MORSO Operating Manual

BEWARE OF THE
EXTREME SHARP
KNIVES
Instructions Manual
MORSØ
Notch Cutting Machine
Model NF
SERVICE

Adjustment of Springs

The springs (1) that move the knife block (2) to the
top position are by means of the spring holders (3)
fastened in the bottom holes in the sides of the
frame.
If the up and down movement is not quick enough
or if the springs loose some of their tension after a
while the spring holders (3) can be moved up to
the next hole in the frame.
1. A piece of wood is placed under the knives on
the table (4) in order to keep the knife block (2)
up.
2. Loosen nut (5)
Only on the side you are adjusting.
3. Pull off the outer washer (6).
4. By means of a suitable tool the spring (1) is
lifted so much upwards that the spring holder
(3) can be moved to the next hole.
5. Put back washer (6) and nut (5) and fasten.
6. The same procedure on the other side.
H-5