Cutting Of Bars With Rebate - Hoffmann MORSO Operating Manual

BEWARE OF THE
EXTREME SHARP
KNIVES
Instructions Manual
MORSØ
Notch Cutting Machine
Model NF
CUTTING OF BARS G-1

Cutting of bars with rebate

With the MORSØ-NF machine it is also possible
to cut bars with rebate.
You must make support mouldings (1) and
support blocks (3) for the rebate in the bar. If
these devises are not used the rebate will splinter
during cutting. The support mouldings and support
blocks can be made out of hard wood or nylon.
IMPORTANT: The height of the support blocks (3)
must be approximately 1/10 mm lower that the
height of the rebate.
Use the following procedure:
1. The support mouldings (1) for the bar rebate is
fastened onto the fences (2) with screws.
2. The support blocks (3) are fastened on the
cock-bead stops (4) with screws.
All adjustments before cutting are the same as
described on pages F-1 to F-5.
The carving of the coggin takes place manually on
a circular saw or a spindle moulder.