Stealth B-52 Owner's Manual page 8

2. INSTALL THE FRONT WHEEL
For ease of transport, your bike may come with the front wheel uninstalled. The 20mm thru axle needs to be correctly
inserted into the dropout when installing the wheel.
DNM forks
Loosen clamps (5mm Allen
key) and remove axle lock
nut (8mm Allen key). Remove
axle from fork legs.
MRP or SR Suntour forks
If your bike is equipped with MRP or SR Suntour forks see their respective manuals for wheel and axle installation.
3. INSTALL THE PEDALS
The B-52 model may come with the cranks removed from the SR Suntour V-boxx. To install these cranks insert them onto
the axle on either side of the bike. Make sure the cranks are parallel and oriented opposite ways. They are tightened with a
torque wrench hex key to the specified torque value.
The other stealth models have the cranks already installed. The pedals need to be installed on the correct side. The right-
hand crank and pedal has a standard thread and the left side has a reverse thread. The pedals should be tightened by hand
Remove stem cap
Put wheel in place being careful
that the brake rotor sits within
the calliper. Slide axle through
hub. Note: sprung fork leg will
need to be compressed slightly to
allow axle to install
STEALTH ELECTRIC BIKES OWNER'S MANUAL
Hold assembly for
ease of installation
Tighten lock nut with
key
8mm Allen
Tighten clamps with 5mm
Allen key. Spin wheel and test
brakes before riding.
V 2.4 PAGE | 8