Battery Care - Stealth B-52 Owner's Manual

Follow the steps below to charge your stealth battery:
i. Ensure the bike is switched off and the charge port is clean and dry.
ii. Connect the charger to the wall socket. A red and a green light should illuminate.
iii. Now connect the charge plug to the charge socket located on the front LHS of the bike. The charger should then
display 2 red lights, and the charge cycle should commence.
iv. The complete charge period should last approximately 2-3 hours (depending on model). At the end of the charge
cycle the charger will illuminate 1 red and 1 green light. This indicates that the battery is fully charged and the
charger can be disconnected.
Ensure bike is turned off
NOTE: Red and green lights may cycle on and off toward the end of the charge period. This indicates that the battery is
balancing and it is best to wait until the cycling has stopped to get the best from your battery pack.

BATTERY CARE

1. If less than 40% of the battery life remains, charge after use. Otherwise, only charge before use.
2. For maximum battery life, it is always best to store your battery between 40% and 60% of it is at maximum charge.
3. Exercise caution when removing the battery pack. Always ensure that hands are dry and never insert any object
into the ends of the battery connectors.
4. Do not drop, or throw the battery and avoid puncturing or subjecting the battery to excessive vibration or impacts.
Ensure charge port is clean
and dry
Two red lights are displayed
when battery is charging.
You should also be able to
hear the fan running
STEALTH ELECTRIC BIKES OWNER'S MANUAL
Connect charger to charge
port
A red and green light is
displayed when charger is
disconnected from bike or
battery is fully charged
V 2.4 PAGE | 19