Monogram Advantium ZSB9131NSS Installation Instructions Manual page 10

Flush Mount Installation Preparation
PREPARE THE OPENING
The Advantium Built-In Oven can be installed beside
another Advantium Built-In Oven in a side-by-side
combination.
Double Advantium Built-In Oven
Installation:
Cut the opening in a cabinet to the dimensions shown.
• Center divider acts as cleat for side of each respective
unit. Only one additional side cleat needed per oven
cutout.
• The support must be level and rigidly mounted, flush
with the bottom edge of the cutout.
Dimension 1/8" Reveal
G 59-7/8"
H 5-1/8"
I 27-3/8"
PREPARE THE OPENING
Installation under a 30 or 36 Cooktop or Countertop:
Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for the cutout size.
See the label on top of the oven for approved cooktop models. This oven requires a separate from the cooktop,
properly grounded 15-Amp, 120-Volt, 60Hz power supply. Use a 36 or wider base cabinet.
23-1/2
4 High
Toekick
10
1/4" Reveal
60-1/4"
5-1/4"
27-1/2"
1-1/2 Min.
Cooktop
Cooktop
J*
20 5/8"
36-3/4"
Min.
25
36
Countertop
Height
20-1/2"
Cooktop height including
depth of electrical box
on some models. Refer
to cooktop installation
instructions.
No minimum clearance
required between cooktop
and oven.
*See table for desired reveals on sides.
Dimension
J
23-1/2" min.
G*
H*
I*
I*
Door Depth (See table below)
Model Door Depth
ZSB9131NSS 1-3/8"
ZSB9132NSS 1-7/16"
Construct solid bottom
- Min. 3/8" plywood
supported on all four
sides. Must be able
to support weight of
oven and contents.
*1/8" reveals on
sides and top
1/8" Reveal 1/4" Reveal
30" 30-1/4"
31-7000079 Rev. 0