Input/Output - SystemAir Combi Unit Genius Installation, Operation And Maintenance Instructions

10.6

Input/Output

Genius
Heat pump
Status
Heating/Cooling
Capacity requirement
Defrost
Temp. air heat exchanger
Temp. suction gas
Cond. Temp.
Temp. hot gas
Zone hot gas
Status hot gas
Cond. pressure
Evaporator pressure
Differential pressure
Requested capacity comp.
Actual capacity comp.
Actual speed comp.
Status envelope curve
Alarm countdown
Pressure ratio
Low pressure countdown
Extern. Fan
Compressor
4-way valve
Overheating
Valve status
Valve status
Valve status
Input/Output
Figure 22: Page
10.6.1 Heat Pump
You can read the most important actual heat pump status. This is very useful during an error analysis. The parameters of the cooling cir-
cuit can only be read and if possible adjusted with the external control, see „9.3.1 External Heat Pump Control" page 46.
56
Operation/Control via Internet/App
Analogue inputs
On AE1, outdoor temperature
Heating AE2, supply air temperature
90 % AE 4, extract air temperature
Off UAE1, hot water temperature
21.1 °C UAE2, Supply air fan monitoring
21.6 °C UAE3, Extract air fan monitoring
22.0 °C UAE4, Secondary air fan monitoring
27.0 °C Digital inputs
90.0 °C DE1, EVU status
OK DE2, Pressure monitoring alarm
14.2 bar DE3, PV
14.1 bar DE4, Rotor operation
0.1 bar Analogue outputs
0 % AA1, supply air fan control
0 % AA2, extract air fan control
0 U/s AA3, secondary air fan control
27 AA4, Preheater.
180 s Digital outputs
1 DA1,
60 s DA2,
0 % DA3,
DA4, rotor On/Off
Off
On DA5, sum alarm
5 K DA6, storage charge pump
3 DA7, heating rod HW
0 stp
0 %
7.1 °C
23.4 °C
22.0 °C
44.6 °C
10 V
10 V
10 V
On
Off
Off
On
6.0 V
5.5 V
0.0 V
0.0 V
Off
Off
Off
On
Off
Off
Off
Genius - V 1.0