Husqvarna 326R Workshop Manual page 11

2
10
Electrical system
Attach the ignition coil to the ignition
cable.
Still no spark?
Check other cables and connections.
Still no spark?
Check the air gap.
502 51 34-02
Adjust the air gap.
Attach the ignition coil to the ignition
cable and ensure that the wire is folded
along the cable.
Slide the contact coil into the spark
plug cover.
TIP!
Lubricate the hole in the spark plug
cover so that it is easier to slide in the
contact coil.
Still no spark?
Check other cables and connections for
poor contacts (dirt, corrosion, cable
breakage and damaged insulation).
Make sure that the cables are correctly
drawn and lie in the cable grooves.
Do not forget to check the cables in the
throttle too.
See chapter 3 "Throttle".
TIP!
Use an Ohmmeter in order to easily
check if cable breakage has occurred,
due to pinching, for example.
Still no spark?
Check the air gap between the flywheel
magnet and the ignition module. The
gap should be 0.3 mm.
Use a 502 51 34-02 feeler gauge.
Adjust the air gap as needed to the
correct value.
• Loosen the bolts.
• Position the feeler gauge and press
the ignition module against the
flywheel.
• Tighten the bolts and check the air
gap again.
If the spark plug still does not fire, the
ignition system should be replaced.