Husqvarna 326R Workshop Manual page 12

Electrical system
Dismantling
Dismantle the starter, cylinder cover,
guard over the muffler and spark plug.
Unhook the throttle cable from the
carburettor.
NOTE!
Do not lose the rubber bushings fitted between the starter and the fuel
tank.
Remove the screws holding the clutch
cover.
Remove the clutch cover complete with
the shaft from the engine.
NOTE!
Do not lose the rubber bushings fitted between the fuel tank and the
clutch cover.
Loosen the short-circuit cable from the
ignition module.
502 50 18-01
Dismantle the ignition module and the
centrifugal clutch.
502 50 64-01
Dismantling
The following components must be
dismantled for the ignition system to be
accessible.
The cylinder cover, starter, guard over
the muffler and spark plug.
Unhook the throttle cable from the
carburettor.
Remove the three screws holding the
clutch cover on the engine.
Lift off the cover together with the shaft.
Loosen both ends of the short-circuit
cable from the ignition module.
Remove the remaining screws (A)
holding the ignition module and both
screws (B) that hold the centrifugal
clutch.
Lift off the clutch, both support washers
and the ignition module.
2
11