Table of Contents
Advertisement
IMPORTANT!
DISCONNECT ELECTRICAL POWER SUPPLY
BEFORE CLEANING.
DAILY CLEANING
1. The skillet should be cleaned daily.
2. Wash the skillet with a mild detergent and hot water.
If food is stuck to the surface of the skillet pan, soak
it and use a little heat to loosen the food. Then, wash
with clean water and wipe dry.
3. Be sure to wash under the skillet cover and rinse with
clean water.
4. Check the skillet pouring lip corners to be sure they
are clean. Also, wash around the exterior of the skil-
let. Rinse with clean water and air dry.
REPLACEMENT OF TEMPERATURE CONTROL
1. Place circuit breaker in off position.
2. Remove skirted dial knob by loosening two set screws
in the knob. (Use a 5/64 Hex key to loosen screws).
3. Tilt control box up by first removing two pan head
screws in the lower front of the console. Use the prop
up arm located inside, in the rear vertical column, to
keep the console cover tilted open.
4. Disconnect all wire leads from temperature control.
NOTE: Leads should be marked appropriately to fa-
cilitate re-installation.
5. Remove temperature control by removing two (2) pan
head screws from side of control box.
6. Install new temperature control and reverse steps 1
- 5.
ADJUSTMENT OF INTERLOCK SWITCH
1. Tilt skillet pan all the way in the downright position.
2. Place circuit breaker in off position.
3. Tilt control box up by first removing two pan head
screws in the lower front of the console. Use the prop
arm located inside, in the rear vertical column, to
keep the console cover tilted open.
4. To reduce the angle where the switch disengages
when the pan is tilted, use a pair of heavy duty needle
nose pliers and lightly bend the tilt tab on the trun-
nion up. To increase the angle, bend the tilt-tab down.
Test by tilting the pan and checking at what angle the
switch clicks. The switch should click off at approxi-
mately 10E tilt of the pan from the horizontal position.
5. Close and fasten the control console by tightening the
two screws at the lower front of the box.
6. Place circuit breaker in on position.
ADJUSTMENT OF MOTOR TILT-STOP SWITCHES
1. Tilt skillet pan all the way in the down or horizontal
position until the stops in the back engage.
2. Tilt control box cover up by first removing two pan
head screws in the lower front of the console. Use the
prop arm located inside, in the rear vertical column, to
keep the console cover tilted open. Caution, circuit is
live! Electrical power has not been turned off.
3. Remove control console lower side cover to expose
motor, tilt cam and switches.
4. Using a 9/64 hex key, loosen the two set screws on
the tilt cam located on the outside hub of the tilt gear.
5. Turn the cam so that one of the arms just engages the
upper-right tilt switch as the arm is turned clockwise.
Hold the cam/arm in that location and tighten the set
screws.
6. Using the tilt UP/DOWN switch on the control panel,
test the full travel up and down on the pan. The motor
should stop just before the pan back stops engage in
the horizontal position. It should stop at about 80E in
the up or vertical position.
7. Repeat steps 4 to 6 until motor tilt stops as described
in step 6.
8. Replace the control console lower side cover in its
original position. Close and fasten the control console
by tightening the two screws at the lower front of the
box.
9
Cleaning & Maintenance
MAINTENANCE
Hide quick links:
Advertisement
Table of Contents
