Gamma X-Stringer X-6 Owner's Manual page 10

Remove the frame from the mounting system by loosening the shoulder supports and frame
supports.
STRINGING THE FRAME
Clamping the String
Clamp the tensioned string to the next adja-
cent string using the second string clamp.
Release the string from the gripper by raising
the tension arm.
Repeat the procedure for all of the remaining
main strings and tie off following the racquet
manufacturers recommendations.
Starting the Cross Strings
Follow the manufacturer's recommended
stringing pattern for one or two piece string-
ing. This will determine the starting point for
the cross strings. If applicable, tie the first
cross string using an appropriate starting
knot.
Completing the String Job
Weave the cross strings over and under the
main strings being careful to alternate the
weave of each consecutive cross string so
as to be opposite of the previously installed
cross string.
Once the final cross string is tensioned and
clamped, tie off at the appropriate hole speci-
fied by the racquet manufacturer.
9