Transportation And Storage; Switching On/Off - Enco Control Technical Description

(Figure 20, Figure 21).
Cabinet, where the device is mounted, must be marked with symbol № 5036 on
ISO 3864:
Danger! Risk of death from electric shock.
Environmental conditions:
- Ambient temperature
- Relative humidity

TRANSPORTATION AND STORAGE

 Packed equipment may be transported in any type of covered vehicle. Equipment
should be anchored reliably to avoid shock and possibility to shift inside vehicle.
Transportation temperature from -25
and atmospheric pressure of 84 kPa up to 106,7 kPa.
C
 Equipment should be protected against mechanical damage and shock.
 Equipment should be stored in dry, heated premises, where environment temperature
is not lower than +5
because of corrosion hazard.

SWITCHING ON/OFF

 Switch on the power (Fig. 1). The device is ready for operation.
 Device status indicates LED1 (Fig. 2): Power is on - the LED1 lights up and blinking,
power is off
 The device switches off with the automatic switch (2-pole circuit breaker).
 Automatic switch should be installed close to device and so that it was easily available
to service personnel.
Fig.1 Connection to the mains supply
62 61 60 59 58 57 56 55
PSU 230V
1 2 3 4 5 6 7 8
2A
•
Kulautuvos g. 45a , LT-47190 Kaunas
c
o. No aggressive chemical substances should be stored together
LED1 is not lit.
54 53 52 51 50 49 48 47 46
Enco Control
9 10 11 12 13 14 15 16 17
•
Tel. (+370 37) 360234
from + 5 C to + 55 C,
up to 93 
, relative humidity up to 95  at +25
C to +55 C
45 44 43 42 41 40 39 38 37
18 19 20 21 22 23 24 25 26
•
Faks. (+370 37) 360358
ENCO Control
Technical description
J28 J27
J21 J29
27 28 29 30 31 32 33 34
• •
info@axis.lt www.axis.lt
35 36
3