Meter - Fluke NORMA 6003 User Manual

NORMA 6003/NORMA 6003+/
NORMA 6004/NORMA 6004+
User Manual
corresponding input box, then push ] (Select), and input the corresponding value using the
on-screen keyboard, then move the cursor to OK key on the keyboard, and push ] (Select).
5. Repeat step
3
For I , if Use Measured is selected, the measured current fundamental amplitude is used as the
N
rated current; if Specify is selected, the rated current can be specified.
6. Use the arrow ( M N O P ) keys to move the cursor to the Apply button and push ] (Select).
The settings are not saved to the device if you do not select Apply.
7. Push Q (Back) on the control panel to go back to the previous menu; press the button
continuously to go back to the main screen

Meter

After the Analyzer is turned on, it defaults to the Meter mode, and the current measurements are
displayed in a list on the main screen.
You can also enter the Meter mode by pushing
lists the items displayed on the screen.
Table 12
Item Description
Status Bar
a
See
Range configuration information
Current range information for each module
- The representation with (Auto) indicates auto range, which automatically switches
b
- The representation without (Auto) indicates that the current range is fixed, the
Wiring configuration information
c
Current wiring selection for each wiring group
Update rate
d
The current update rate of the Analyzer. Please see
Rate.
Current state
- Preview: Currently in Preview mode.
e
- User Item: Currently in User Item mode.
- HOLD: Currently in data hold state. The value displayed in the value list area does
Value List
f
The measurement items are displayed in a list according to the user's settings. See
Preview
34
to for hcf settings.
4
Table 12.
for details.
Status Bar
the range according to the signal size.
range of the value displayed and the range will not change with the signal;
not change with the actual signal.
and
User Item View
(Meter) on the control panel.
Meter Screen
for details.
Set Sync Source and Update