MB QUART MBQR-SUB-2 Installation Manual page 7

DASH AREA DISASSEMBLY 2018.5 Turbo S & 2019+ RZR (RIDE COMMAND)
Please note, separate disassembly instructions for the 2013-2018 RZR models are found on pages 5-6 in
this manual.
STEP 1 – REMOVE CENTER HOOD
Remove the center of the hood area as shown in Figure
7-1. Twist the recessed tabs at the upper left and right
corners. Pull up to remove. Next, pull passenger's side
grab bar retaining clip and pin, then firmly pulling the grip
toward the rear of the vehicle.
STEP 2 - REMOVE CENTER SHROUD
Remove (2) plastic push clips behind the center shroud as shown in Figure 7-2a to remove the Ride
Command cover or pocket depending on your vehicle. Cover removed shown in Figure 7.2b.
STEP 3 - REMOVE FULL FRONT COVER DASH TOP ASSEMBLY
Remove (2) T40 screws located by the A-pillars as shown in Figure 7-3a. Next, remove the (2) T40 screws
holding the front of the dash in the inner fender near the water bottle and bus bar. Lift upwards to release the
top of the dash cover and remove as shown in Figure 7-3b.
Figure 7-2a
Figure 7-3a
7
Figure 7-1
Figure 7-2b
Figure 7-3b