Page 1
120 Minutes (2 Hours) Assembly Time: Before you beign, read thought these instructions and check that all parts are present. Please note that MB Quart cannot assume any responsibility for damage resulting from incorrect installation. MBQJT-SUB-1 Parts List Component Name...
Page 2
Disassembly ● Remove (4)10mm bolts securing the under seat storage compartment May need to remove rubber insert to gain access to bolts ● Remove jack Page 2 of 5...
Page 3
Subwoofer Installation ● Cut a small hole in the carpet (as pictured) to pass the subwoofer extension harness through going toward the outside of vehicle along door seal toward the passenger seat area. ● Install jack ● Connect subwoofer enclosure wiring to subwoofer extension harness.
Page 4
Subwoofer Installation ● Reusing the (4) 10 mm bolts holding the storage compartment, secure the subwoofer enclosure ● Connect the subwoofer speaker wires to the subwoofer and repeat the process for other subwoofer ● Secure the subwoofer to the enclosure with (8) High-Low screws using a T-20 Torx bit Page 4 of 5...
Page 5
FCC Notification This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a mobile installation. This equipment generates uses and can radiate radio frequency energy.
Need help?
Do you have a question about the JT and is the answer not in the manual?
Questions and answers