MB QUART MBQR-SUB-2 Installation Manual page 6

DASH AREA DISASSEMBLY 2013-2018 (Non-Turbo S) RZR - Continued
STEP 5 – REMOVE DASH FASCIA CENTER HARDWARE
Remove (4) Torx screws from the front of the dash through the openings shown in Figure 5-6. The first set of
Torx screws will come out allowing access to the second (upper) set further back in the dash. Next, pull the
only the center of the dash loose as shown in Figure 5-7.
Figure 5-6 Figure 5-7
STEP 6 – REMOVE DASH FASCIA HARDWARE
Using a large panel removal tool, release the side clips from the passenger's side front dash assembly as
shown in Figures 5-8 and 5-9. Slowly ensure you account for all clips removed.
Figure 5-8 Figure 5-9
STEP 7 – REMOVE THE GLOVE BOX
Remove (2) 10mm bolts on the top of the glove box
where it is fastened to the grab bar framework. See
holes in Figure 5-10. The glove box will easily slide
out. A different mounting method is used for the new
subwoofer.
Go to page 10 for next steps on these model year
vehicles.
Figure 5-10
6
©2020 Maxxsonics USA, Inc.