MB QUART MBQR-SUB-2 Installation Manual page 10

SUBWOOFER ENCLOSURE MOUNTING (ALL MODELS)
Prepare to mount the subwoofer into the glove box and grab bar location. 2018.5 Turbo S and 2019 and
newer RZR models, use only the rear mounting plate and four 1/2" bolts as shown in Figure 8-1. All other
RZR models use both mounting plates and all eight 1/2" bolts as shown in Figure 8-2.
2018.5 Turbo S
and 2019+ RZR
Models use only
rear mounting
plate and four 1/2"
bolts.
STEP 1 – POSITION SUBWOOFER ENCLOSURE
Sitting on the floor of the RZR, hold the subwoofer enclosure up
to the grab bar pipe and push it forward into place as shown in
Figure 8-3.
STEP 2 – BEGIN MOUNTING ENCLOSURE
Begin mounting the subwoofer to the RZR using the supplied
steel plates and bolts as indicated for your specific year and
model. Start by hand-threading the bolts until finger tight as
indicated in Figure 8-4, Then, use a 1/2 inch socket with a small
ratchet to begin tightening the bolts. Space is tight for any larger
tools, a smaller ratchet will work best.
NOTE – Ensure the wiring harness from the subwoofer does not
get pinched behind the enclosure. This will prevent the enclosure
from seating properly and will not allow the front dash to snap
into place properly The harness should be routed over the top of
the push bar frame to the subwoofer amplifier connector.
STEP 3 – FINISH SUBWOOFER MOUNTING
Tighten a few threads at a time on each bolt to allow the
subwoofer to rise up against the pull bar frame evenly. This will
allow the subwoofer to seat properly against the frame of the
vehicle.
NOTE – When the subwoofer starts to seat into place, continue to
push the subwoofer firmly forward as shown in Figure 8-3 as you
tighten mounting hardware. This forward pressure will be critical when
you reassemble the front dash for fitment into all the clips.
STEP 4 – ROUTE SUBWOOFER WIRING HARNESS
Route the subwoofer enclosure's wiring harness over to the amplifier
area. Connect it to the speaker output of the mono amplifier as shown
in figure 8-5 if adding on to a Stage 2 system.
The next section describes connecting to the amplifier.
Figure 8-1 Figure 8-2
Figure 8-3
Push Forward into Position
10
2013-2018 (non
Turbo) RZR
Models use both
mounting plates
and eight 1/2"
bolts.
Figure 8-4
Mono
Amplifier
Figure 8-5
Subwoofer Enclosure
©2020 Maxxsonics USA, Inc.