Table Support (36)
2. Position the table support on the machine and secure it with the locking knob
(1) and the washer (8).
Base Unit (42)
Washer (3)
Locking Knob (1)
3. Slightly loosen the hex screws on the underside of the sanding table and
adjust the table in such a way that the gap between the table and the sanding
disc is between 1.5 and 2 millimetre wide.
4. Make sure the table is parallel to the disc and tighten the screws. Use the
fence as desired.
5. Adjust the plastic cover under the table in such a way that it fits against the
table from below and the entire disc under the sanding table is covered.
Operation
Washer (8)
Spring Ring (7)
Screw (6)
Table Support (36)
18
Sanding Table (35)
Locking Pin