Siemens SIMATIC MICRO-DRIVE PDC1000 Equipment Manual page 14

Properties
The PDC1000 has the following technical properties:
Property
Control of EC motors
Use in protective extra low voltage
range < 42.4 V/60 V (SELV/PELV):
Current/Power
PDC1000(F)
Equipment Manual, 02/2020, A5E48775040-AA
Description
The PDC1000 is a motor controller for
three-phase motors (EC) with supply
voltages to 48 V DC and permanent
magnets. DC motors are not supported.
Supply voltage:
24 V DC for the logic unit (1L+, 2L+)
•
24 V DC to 48 V DC for the power
•
unit (4L+)
Maximum voltage of the power supply
units under fault conditions:
< 42.4 V DC for the logic unit (1L+,
•
2L+)
< 60 V DC for the power unit (4L+)
•
Output phase current I [A] for EC
eff
motor
Nominal 17 A
•
Maximum 35 A
•
PDC1000 6BK1630-1BA00-0AA0:
•
– Nominal 14.5 A
– Maximum 29 A
Output phase current I
peak
motor
Nominal 24 A
•
Maximum 49.4 A
•
PDC1000 6BK1630-1BA00-0AA0:
•
– Nominal 20.5 A
– Maximum 41 A
Typical power output S [VA] for 24 V
el
supply
Nominal 500 VA
•
Maximum 1000 VA
•
PDC1000 6BK1630-1BA00-0AA0:
•
– Nominal 425 VA
– Maximum 850 VA
Typical power output S [VA] for 48 V
el
supply
Nominal 1000 VA
•
Maximum 2000 VA
•
PDC1000 6BK1630-1BA00-0AA0:
•
– Nominal 850 VA
– Maximum 1700 VA
Additional information
Section Connecting the motor
(Page 26).
Section Technical Specifications
PDC1000 (Page 32).
Section Technical Specifications
PDC1000 (Page 32).
[A] for EC
Product overview
2.2 Properties
13