tagarno FHD PRESTIGE Manual page 7

OPERATION | XPLUS FHD CONTROL BOX (2/4)
XPLUS FHD Control box for TAGARNO FHD functions.
Do only connect equipment distributed by TAGARNO.
Dimensions
H: 45mm/1.8" | W: 120mm/4.7" | D: 150mm/5.9".
On screen display (OSD)
The on-screen display provides you with the relevant information
when you push a button on the control box or Setup menu.
For instance if you change the level of magnification, the white
balance, iris, etc. In this way you always know which function you are
activating and which parameters you are using.
Zoom
Push this button on the control box to zoom in.
Push this button on the control box to zoom out.
The magnification level will show via On Screen Display.
Manual and Auto exposure mode
Open current exposure mode menu with key arrows up
and down in standard magnification mode or any active
application. Then, navigate the menu with arrows up and
down and adjust each setting with key arrows left and
right.
Switch between Manual and Auto exposure mode with a
short press to the round center button.
In Manual exposure mode, you can manually adjust the
iris, gain and exposure time with key arrows left and right.
Activate advanced camera settings in the microscope
camera settings to also enable contrast, saturation,
sharpness and noise reduction adjustment.
These settings will also be activated in Auto exposure mode.
Otherwise, exposure compensation is the only setting
visible. Iris, gain and exposure time will automatically be
adjusted to recommended settings and cannot be adjusted
in this mode.
Wait a few seconds for the menu to close and save your
settings.
Manual focus
Turn autofocus off by pushing both zoom buttons (plus
and minus) on the control box at the same time until you
hear a beep. You can now adjust focus manually with the
help of the zoom buttons.
Push this button on the control box to adjust focus if you
wish to focus on something very close.
Push this button on the control box to adjust focus if you
wish to focus on something that is farther away.
To turn the autofocus on again, simply push both zoom
buttons (plus and minus) at the same time until you hear
a beep. The focus values will show via On Screen Display.
Setup menu
Access the Setup menu by pressing the round center
button for 1 second. See separate section regarding
the Setup menu.
7