Cleaning The Media Cleaners - Epson SC-F10000 Series User Manual

SC-F10000 Series User's Guide
A
Put the cup supplied with the Cleaning Kit on the
tray, and pour approximately 10 ml of Cleaning
liquid into the cup.
B
Dampen the cleaning stick with Cleaning liquid.
When doing this, do not allow Cleaning liquid to
drip from the cleaning stick.
c
Important:
❏ Do not use Cleaning liquid that you have
used for cleaning to clean the next time.
Using dirty Cleaning liquid will make
staining worse.
❏ Tightly close the lid of the Cleaning liquid
and store it at room temperature out of
direct sunlight and away from high
temperatures or humidity.
❏ Used Cleaning liquid and cleaning sticks
are industrial waste. Dispose of them in
the same way as for waste inks.
"Disposal of used consumables" on
U
page 139

Cleaning the media cleaners

If the media cleaners are dirty, they cannot sufficiently
wipe dirt and dust off the surface of the media, so there is
a risk that problems may occur, such as clogged nozzles.
If the Clean the media cleaner. After cleaning is
complete, press [OK]. message appears on the control
panel's screen, use the supplied media cleaner brush to
clean them.
Maintenance
A
Check the on-screen message, and then move to
the back side and remove the media cleaners.
While pressing the tabs on both sides, pull it off.
B
Use the supplied brush to wipe dirt and dust from
the surface.
Since the brush's surface has a direction in which
to wipe, move it in the direction that wipes off the
dirt and dust.
Note:
You can switch the direction in which to wipe.
109