Supported Media; Moving And Transporting The Printer; Moving The Printer - Epson SC-F10000 Series User Manual

SC-F10000 Series User's Guide

Supported Media

The following media can be used with the printer.
Print quality is greatly affected by the type and quality of
media used. Choose a media suited to the task at hand.
For information on use, refer to the documentation
supplied with the media or contact the manufacturer.
Before buying media in large quantities, try printing on
a smaller sample and check the results.
Caution:
Because the media is heavy, it should not be carried
by one person.
We recommend using a lifter for media that weighs
over 40 kg.
c
Important:
Do not use media that is wrinkled, scuffed, torn, or
dirty.
Roll media
Roll core size 2 or 3 inch
Roll outer diameter Up to 250 mm
Media width 300 to 1950 mm (76 inches)
Media thickness 0.04 mm to 1.00 mm
Roll weight
Maximum 60 kg
* The specifications for lifters that can be used to load media
that weighs over 40 kg are as follows.
• Thickness of the fork and table: under 28 mm
• The surface of the fork and table can be lowered
approximately 190 mm from the floor.
Appendix
Moving and Transporting
the Printer
This section describes how to move and transport the
product.

Moving the Printer

This section explains how to move the printer to another
location on the same floor. See below for information on
moving the printer between floors or to another
building.
U
What You'll Need
Use the following items supplied with the printer to
move it. Prepare them and keep have them handy before
you start working.
❏ Spanner
❏ Hex wrench
*
The printer is heavy, so use 5 people to move it.
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to observe
this precaution could result in the printer falling
over, causing accidents.
179
"Transport" on page 189
Use to turn the nuts on the adjusters.
Use when securing the print head.
Caution: