Media - Epson SC-F10000 Series User Manual

SC-F10000 Series User's Guide

Media

Media Jams.
Is media curled, folded, curved, creased, or
o
waved?
Cut and remove the curled, folded, curved, creased, or
waved part.
"Cutting Media" on page 85
U
Is media loaded just before printing?
o
The pressure rollers may crease media left in the
printer, or the media may also become wavy or curled.
Is the media too thick or too thin?
o
❏
Check the media specifications to determine
whether it can be used in the printer.
"Supported Media" on page 179
U
❏
For information on how to configure print
settings using the software RIP, contact the RIP
manufacturer.
Is Paper Suction set too high?
o
In the media settings, reduce Paper Suction (the force
that sucks media down the media path).
"Media Setting Item" on page 160
U
Removing Jammed Media.
Follow the steps below to remove jammed media.
Caution:
Be careful not to trap your hands or fingers when
opening or closing the front cover. Failure to observe
these precautions could result in injury.
Problem Solver
A
Move the lock levers on the left and right sides
outwards to open the front cover.
B
While holding the tabs of the media edge plate on
both sides, move the plate out of the way toward
both edges of the platen.
C
If the print head is over the media, move it away
from the jam.
c
Important:
Move the print head only after moving the
media edge plates out of the way. Contact with
deformed media edge plates could damage the
print head.
174