Setting The Water Level Adjustment - Whirlpool BHDH2500FS0 Use And Care Manual

Water kvel
adJustmalt
\
Water level
control switch
c
\
@
//
&y 0
4. -
6
3\
' --a
e'
Normal fill screw
Msxknum fill
Ddcw control
NOTE: Do not operate dehumidifiir at tempera-
tures below 18.3% (65°F). The coils may
become iced over and unit will not operate
Properly.
Your dehumidifier is equipped with a feature to
help you get the most comfort from your new
appliince by permitting it to operate down to
18.3% (65°F). If your dehumidifier runs when
room temperature and humidity conditions are
low, frost can form on its evaporator coil. This
interferes with proper operation.
The De-icer Control senses frost buildup on
the evaporator coil and automatically shuts off
the compressor. The fan conttnues to run,
drawing air across the coil, and melting the frost.
When the coil is defrosted, the compressor
automatically restarts, and dehumidifying
resumes.
Setting the water level
adjustment
The Water Level Adjustment can be set in two
positions to turn off the unit automatically when
the pan is full. This prevents the danger of
overflow.
Pan must be in proper position for Water Level
Control Switch to work.
l
NORMAL FILL - set Water Level Adjustment
to the indentation on the left side. The water
pan and water will weigh approximately 7.2 kg
(16 Ibs.) and water pan will be 'h full.
l
MAXIMUM FILL - set Water Level Adjustment
to the raised area on the right side. The water
pan and water will weigh approximately 10.8 kg
(24 Ibs.) and water pan will be % full.
The Water Level Control Switch will automatically
turn off the dehumidifier at the fill level you
selected when pan ia property placed. Loosen
the screw to move the Water Level Adjustment.
Retighten screw when adjusted to desired
setting.
7