Setting The Water Level Adjustment - Whirlpool AD0402XS0 Use & Care Manual

To Operate:
1. Turn Humidistat Control to UNIT OFF. then plug in
the dehumidifier.
3. If you need more dehumidification, tzn control
to a higher number. Unit will run continuously at
DRYEST setting. If you need less, set on a lower
number.
2. Your dehumidifier has an automatic humidi-
stat. Turn Humidistat Control left toward DRYEST
for normal operation. Set at number 5 or 6 to
start. Adjust later, if necessary.
When humidity in the room increases, the
dehumidifier automatically starts. When the hu-
midity decreases to the selected level, the de-
humidifier automatically stops.
4. Stop the unit manually by turning the control to
UNIT OFF
Setting the Water Level Adjustment
All models except the 15 pint (7.0 L) capacity model have an adjustable water level.
The Water Level Adjustment can be set in two positions to automatically turn off the unit
when the pan is full (water level will be 1 to 4 inches from top of water pan). This prevents
the danger of overflow.
Pan must be in proper position for Water level Control Switch to work.
NORMAL FILL -
Water Level Adjustment set on the
left side indentation. The water
pan will be slightly more than %
full. The water pan and water will
weigh approximately 16 Ibs. (7.2
kg).
MAXIMUM FILL -
Move the Water Level Adjustment
to the raised area on the right
side. The water pan will be ap-
proximately 3/d full. The water pan
and water will weigh approx-
imately 24 Ibs. (10.8 kg).
The Water Level Control Switch will automatically turn off the dehumidifier at the fill
level you selected when pan is properly placed. Loosen the screw to move the Water
Level Adjustment. Retighten screw when adjusted.