Hardware Installation; Network Connection - Draytek Vigor2927 Series Quick Start Manual

3 . H a r d w a
3 . H a r d w a
This section will guide you to install the router through hardware connection and
configure the router's settings through web browser.
Before starting to configure the router, you have to connect your devices
correctly. (For the hardware connection, we take "ac" model as an example.)
3 . 1 N e t w o
3 . 1 N e t w o
1. Connect the cable Modem/DSL Modem/Media Converter to any WAN port of
router with Ethernet cable (RJ-45).
2. Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of the
router and the other end of the cable (RJ-45) into the Ethernet port on your
computer.
3. Connect one end of the power adapter to the router's power port on the
rear panel, and the other side into a wall outlet.
4. Power on the device by pressing down the power switch on the rear panel.
5. The system starts to initiate. After completing the system test, the ACT LED
will light up and start blinking. (For the detailed information of LED status,
please refer to section 3. Panel Explanation)
r e I n s t a l l a
r e I n s t a l l a
r k C o n n e c t i o
r k C o n n e c t i o
t i o n
t i o n
n
n
11