Troubleshooting; Status Check Led - Pentair ChemCheck Installation And Service Manual

10

TROUBLESHOOTING

Status Check LED

A quick flow, connectivity and electrode status check can be performed by pressing the blue Status Button on top
of the ChemCheck. This button, and its accompanying LED, are located between the WiFi Antenna and Electrode
Connection.
Note: Water balance readings will pause for 5 minutes after the Status Button is pressed. If all status checks were
successful (Solid Blue, Solid Green, and Solid Purple LEDs) readings will restart after this pause.
Start a status check sequence by pressing the Status Button once. The Status LED will illuminate and ChemCheck
will cycle through the three separate status checks. The chart below shows the order in which statuses will display and
what specific LED behaviors mean:
LED BEHAVIOR
Solid BLUE
FLOW
Blinking BLUE
Solid GREEN
Blinking ORANGE
WIFI
CONNECTIVITY
Solid RED
Blinking YELLOW
Solid PURPLE
ELECTRODE
Blinking PURPLE
CHEMCHECK™ Water Quality Monitor Install and Service Guide
STATUS
Sufficient water flow through
ChemCheck
Insufficient water flow through
ChemCheck
Adequate signal between
ChemCheck, WiFi router and Pentair
Home app
Adequate signal between ChemCheck
and WiFi router; but weak or broken
signal between router and Pentair
Home app
Weak or broken signal between
ChemCheck and WiFi router
ChemCheck is in WiFi pairing mode
Electrode properly connected to
ChemCheck
Electrode improperly connected to
ChemCheck
CORRECTIVE ACTION
None required
Inspect system valves and water
connections.
Ensure both ChemCheck flow valves are
open.
Ensure ChemCheck has been mounted
level.
None required
Ensure other devices can connect to WiFi
and repair internet connection accordingly.
Ensure WiFi router is on and broadcasting a
signal.
Relocate ChemCheck to an area with
stronger WiFi signal.
Purchase and install an SMA-connected
antenna extender.
Purchase and install a WiFi extender.
None required
None required
Ensure the electrode connector is correctly
and tightly threaded onto the electrode
terminal.