Rtc Operation - Fujitsu MB2146-450-E Setup Manual

3.5.6 RTC Operation

When system is powered on, the RTC timer begins to count. When user wants to enter
standby mode, the sleep mode can be selected by setting the timer; after setting standby
time, counter count continuously and enter sleep mode when the counter value is same with
the set value.
Following operation describes the standby time setting.
Pressed mode key ---switch to RTC mode
press confirm key to enter EDIT status
Pressing left or right (select LED to change)
standby time to 0hour 4minutes and 30seconds
press confirm key to ensure this setting
MB2146-450-E Setup Guide
Chapter 3 EV-board Manual
Status
up or down key to change the value, set
MCU-AN-500072-E-10 – Page 26
Hour Minute Second