I2C Module; A/D Module - Fujitsu MB2146-450-E Setup Manual

3.4.3 I2C Module

There are two switches between at24c08 and EEPROM, when using i2c to visit EEPROM, it
will switch off and when using i2c to visit other external chip, it will switch on. Following
settings is recommended:
Modules
EEPROM
External chip

3.4.4 A/D Module

Key module and temperature module use the ADC to detect the real-time operation and
environment temperature.
For key module please refer to the following figure 3.4.4 - 1
MODE
USER
LEFT
DOWN
MB2146-450-E Setup Guide
Chapter 3 EV-board Manual
Header name
SW1: on.
SW2: on
SW1: off.
SW2: off
Table 3.4.3 - 1 I2C Switch
Figure 3.4.4 - 1 Key Module
MCU-AN-500072-E-10 – Page 18
Settings
SW1
SW2
SW1
SW2
CONFIRM
SEND
RIGHT
UP