Hw Module Description; Power Module; Bgma Interface; Test Pin - Fujitsu F2MC-8FX MB95390 Series Setup Manual

EV Board MB2146-441-E Setup Guide
Chapter 2 EV Board Introduction

2.4 HW Module Description

2.4.1 Power Module

Input external power supply from outside. Please read the following instructions before using.
Output voltage: 5V
Output Current: 500mA
Connection: Power connector (DC IN)

2.4.2 BGMA Interface

To start debugging using a BGMA, users can connect IDC10 socket from the BGMA to
BGMA IF on an EV board before power on.

2.4.3 Test Pin

All MCU ports are easy accessible through test pins.

2.4.4 Connector

The EV board can be connected to MB95330 EV board through the four 8-pin connectors.
Then the EV board can support 120 degree inverter motor driving solution.
Page 13