Festo DAPZ AR Series Operating Instructions Manual page 27

DAPZ−...−AR
Fastening the DAPZ−...−AR to the rotary drive
1. Place the DAPZ−...−AR with the foot
guides onto the pre−fitted feet.
For different rotary drives the
distance 2 to the step of the
DAPZ−...−AR can be in stages of 20,
30, 40 or 50 mm.
2. Push the DAPZ−...−AR over both feet
until step 1 of the cam shaft enters
the cutout in the rotary axis.
3. Make sure that the holes on the sides
for the feet and the foot guide are aligned exactly (see Fig. 9).
Only if the holes are aligned accurately can the position of the DAPZ−...−AR over
the rotary drive be defined.
Fig. 9
4. Press a clip into each of the foot guides of the DAPZ−...−AR.
The clips must be heard to snap into position.
Festo DAPZ−...−AR 0512a English
1
Fig. 8
2
Fig. 10
27