Table of Contents
Advertisement
Quick Links
User's Manual
8'x10' Folding Trampoline Combo
STFC10G09
Model _________________
WARNING
!
Read all precautions and
instructions in this manual before
using this equipment. Save this
manual for future reference.
Maximum user weight 200 lbs.
IMPORTANT
!
Trampoline/Enclosure's are
susceptible to winds. Be sure to
secure your
Trampoline/Enclosure. Wind
Damage is not covered in the
TM
warranty of your trampoline.
Advertisement
Table of Contents
Related Manuals for Skywalker STFC10G09
Summary of Contents for Skywalker STFC10G09
- Page 1 User’s Manual 8’x10’ Folding Trampoline Combo STFC10G09 Model _________________ WARNING Read all precautions and instructions in this manual before using this equipment. Save this manual for future reference. Maximum user weight 200 lbs. IMPORTANT Trampoline/Enclosure's are susceptible to winds. Be sure to secure your Trampoline/Enclosure.
-
Page 2: Table Of Contents
STFC10G09 Model _________________ A model decal is found on one of the trampoline legs. Write the model number and serial number in the space above. CONTENTS Trampoline Important Precautions ....................Enclosure Important Precautions ....................Warning Label Placement ......................... Before You Begin .......................... -
Page 3: Trampoline Important Precautions
TRAMPOLINE IMPORTANT PRECAUTIONS 11. If you do not use the trampoline correctly someone can be seriously hurt. ! WARNING: To reduce the risk of serious injury, read and follow all of the warnings, precau- 12. The trampoline should only be used with a proper tions, and instructions in this manual before you understanding of the safety precautions, and under assemble (put together) and use the trampoline. -
Page 4: Enclosure Important Precautions
ENCLOSURE IMPORTANT PRECAUTIONS 12. This trampoline enclosure is made for users who do not ! WARNING: To reduce the risk of serious injury, read weigh more than 250 pounds and children less than 6 years and follow all of the warnings, precautions, and instructions old should not use it. -
Page 5: Warning Label Placement
Note: The labels and placard are not shown actual size. BEFORE YOU BEGIN Thank you for choosing a SKYWALKER TRAMPOLINES Brand Trampoline. The SKYWALKER TRAMPOLINES Folding Trampolines are designed and crafted to provide many years of fun and fitness. This trampolines comes equipped with warnings and instructions for the assembly, care, maintenance, and use of the trampoline. -
Page 6: Trampoline Safety Information
TRAMPOLINE SAFETY INFORMATION In trampoline use, as in all active recreational sports, participants can be injured. However, there are steps that can be taken to reduce the risk of injury. In this section, primary accident patterns are identified and the responsibilities of supervisors and jumpers in accident prevention are described. -
Page 7: Enclosure Safety Information
ENCLOSURE SAFETY INFORMATION NEED FOR TRAMPOLINE ENCLOSURE SAFETY A trampoline enclosure is a recreational product. The information on this page and on pages 8-9 identify important safety precautions. The precautions are not all- inclusive, because an enclosure can be used in ways that this manual cannot cover completely. To prevent pinches and cuts during enclosure use, a frame pad must be installed on the trampoline. - Page 8 Hazards Associated with High Winds A trampoline with an enclosure can be moved or blown over by high winds. Anyone in its path, or inside of the enclosure, may be injured if this happens. If you expect high winds, take down the enclosure netting and stake the trampoline frame to the ground (see page 10), or move the trampoline and enclosure to a sheltered location.
- Page 9 Wear clothing that does not have drawstrings, hooks, loops or anything else that could get caught in the netting. Do not attach anything to the netting that is not a Skywalker Holdings, LLC approved accessory or part of the of the trampoline enclosure.
-
Page 10: Methods Of Accident Prevention
METHODS OF ACCIDENT PREVENTION The Supervisor’s Role in Preventing Accidents It is the responsibility of the owners of trampoline users to provide knowledgeable and mature supervision. They need to know and enforce all of the rules and warnings printed in this manual to minimize the likelihood of accidents and injuries. -
Page 11: Use And Instructional Material
Climb onto and off of the trampoline. Do not jump onto or off of it. Do not use the trampoline as a springboard to jump to other objects or places. For additional information regarding equipment, contact Skywalker Holdings,LLC. For additional information regarding skill training, contact a trainer certification organization. -
Page 12: Instructional Program And Model Lessons
INSTRUCTIONAL PROGRAM AND MODEL LESSONS The following lessons are examples of an instructional program. They should follow a complete discussion and demonstration of body mechanics between the supervisor and the student(s). See pages 13 and 14 for descriptions of basic trampoline skills. Lesson 1 1. -
Page 13: Basic Trampoline Skills
BASIC TRAMPOLINE SKILLS Fundamental Bounce Knee Drop 1. Start from a standing position with your head erect and 1. Start bouncing from a standing position, keeping your your eyes on the frame pad. eyes on the frame pad. 2. Swing your arms forward and up in a circular motion. 2. - Page 14 Seat Drop Front Drop 1. Land in a sitting position with your legs parallel to the 1. Start from a low bounce and land on the mat in a prone mat. position. 2. Place your hands on the mat beside your hips. 2.
-
Page 15: Trampoline Assembly
TRAMPOLINE ASSEMBLY IMPORTANT ASSEMBLY INFORMATION • Need phillips screw driver and 2 adjustable wrenches (putting the trampoline together). A rubber mallet may make assembly easier, however. • Assembly requires two persons. • Wear gloves to protect your hands from pinch points during assembly. TRAMPOLINE PLACEMENT 1. - Page 16 INSIDE of Assembly Bolt Hole Pin Holes OUTSIDE of Assembly Attach one “T” joint（7）to the frame tubes (3/6) with two M8x55mm Shoulder Bolts During assembling the “T” joints(7) in (21) and two M8 Locknuts（26）as shown. Make sure the center of the step 4, one person holds one half frame as corresponding holes be aline refer step5.
- Page 17 Leg Assembly Slide Slot Straight Edge Straight Edge Attach one leg assembly to the frame assembly at the pivot points marked with “A” and “B” with two protective plates (22) two M8x40mm bolts (23) and two M8 Locknuts (26) each for side. Make sure that the straight edges of the protective plates against the bracket as shown.
- Page 18 Left Right Two persons lift the frame assembly up from two sides as left picture shown, until the top frame is level as right picture shown。 INSIDE of assembly Socket Pin Pin Hole Spacer Socket Pin Pin Hole OUTSIDE of assembly One hand lift the frame tube, have another hand turn over the “T”...
- Page 19 Warning Label Warning Label Jump mat Lay the jump mat on the ground inside the frame as shown. Make sure the warning labels are top, and located corresponding to the support legs(13) each side. Hook Warning label Band “D”-ring frame tube Tool Inset Start from the long frame tubes with pivot(4) attached with the support tubes, hook the band(33)to the first hole near the Pivot on...
- Page 20 Wheels assembly Right leg1 Support Tube Big “C” ring Big “C” ring Clip the big “C” rings (32) to the Left leg tube 2 and Rig- Attach the wheels assembly to the right leg tube1 with ht leg tube1 (8&9), making sure that the open part of the the support foot(18), located right side of the big “C”...
-
Page 21: Enclosure Assembly
ENCLOSURE ASSEMBLY two holes lower pole(15) upper pole(16) Lay both the upper (15) and lower enclosure poles (16) on the ground, then attach the tubes with an M4.8x16 screw (27) and Lock Washer (31). Attach the remaining top and bottom enclosure poles together in the Expand the enclosure net (14) on the ground and samew manner. - Page 22 Bracket Button Press the button in the tube, and insert the end of the Repeat step7 to attach the remaining 5 poles into their pole into the bracket until the button pops out and locks frame brackets. the pole into place. Note: Insert the Pole slowly to make sure not pinch your fingers.
-
Page 23: Fold Trampoline Combo
Straps Pad Flap Support Attach one Pad Flap to the Support Leg with tying the To adjust the tension on the net top tie straps of each pole straps on the bottome of the Pad Flap around the Support together as the insert drawing shows. Leg. - Page 24 Lock Pin Socket Pin Socket Pin Remove the indicated Lock Pin from the Socket Pin. Make sure you finish the step 2 and 3 above before Then two persons open the socket pins from two sides you start this step. Follow step 3, move the support as shown at the same time.
- Page 25 The insert drawing Insert the pins into the holes on the opposite brackets, lock it as the insert drawing shown. This will lock the trampoline together in a folded state. Make sure that one person is always holding the folded trampoline steady, so it does not fall over.
-
Page 26: Open Trampoline Combo
OPEN the Folding Trampoline & Enclosure The trampoline w/ enclosure can be opened as illustrated for using after being folded, please follow these steps: Suppor Foot Close the Support Foot until they clip to the leg tubes as shown Lock Wheels Assembly The insert drawing... - Page 27 Insert the locking pins into the “T” brackets from two Two persons open the trampoline until the jump mat is to be level as sides, as shown above. shown. Make sure no any side of the jump mat bounces back. Suppor Leg Right Leg Assembly Two persons lift the trampoline up from two sides as shown, holding...
- Page 28 Brace Tube Attach the brace tubes(13) to the joints on the frame tubes with pin as shown. Wheels Assembly Refer to step 19 on page 20 to attach the wheel assembly to the leg tube. Finish the enclosure assembly, refer to steps 6-14 on page 21 until completely assembled and all connections checked by a supervisor prior to use.
-
Page 29: Care And Maintenance
CARE AND MAINTENANCE CARE Do not allow pets on the trampoline, as their claws may snag and pull the mat material or damage the frame pad. The trampoline is intended to be used by one person at a time who weighs not more than 250 pounds. The user should be either barefoot, wearing socks, or wearing gymnastic shoes. -
Page 30: Expolded Drawing And Part List
PARTS LIST Key No. Descrption Qty. Key No. Descrption Qty. Suppot foot Frame Cover Wheel Jumping Mat Connecting Rod Short Frame Tube M8x55mm Shoulder Bolt 4 Long Frame Tube with Pivot Protective plate Long Frame Tube with Socket 2 M8x40mm Bolt Short Frame Tube with Joint M8x45mm Bolt “T”... - Page 31 Left Leg 1(1) Left Leg 2(1) Right Leg 1(1) Right Leg 2(1) Middle Tube (2) Rope (3) Lower Poles (6) Upper Poles “T” connector (2) Suppot Leg (2) Brace Tube (2) Door 19 1 7 FoamTube(12)
- Page 32 M8x55mm Shoulder Bolt(4) (14) (10) Safety Placard(1)
-
Page 33: Ordering Replacement Parts
ORDERING REPLACEMENT PARTS To order replacement parts, visit our web site at www.skywalkertrampolines.com or call our toll-free Customer Care Hot Line at 1-866-603-Jump (5867), Monday through Friday, 8 a.m. until 5 p.m. Mountain Time (excluding holi- days). To help us assist you, please provide the following information when calling: •... -
Page 34: Limited Warranty
(90) days after the date of purchase. All warranty coverage extends only to the original retail purchaser from the date of purchase. Skywalker Holdings, LLC obigation under this Warranty is limited to replacing or repairing, at Skywalker Holdings, LLC option, the product at one of this authorized service centers.
Need help?
Do you have a question about the STFC10G09 and is the answer not in the manual?
Questions and answers