Reload - Cisco WLC 5700 Series Command Reference Manual

High Availability Commands

reload

To reload the stack member and to apply a configuration change, use the reload command in privileged EXEC
mode.
reload [/noverify| /verify] [LINE| at| cancel| in| slot stack-member-number| standby-cpu]
Syntax Description
/noverify
/verify
LINE
at
cancel
in
slot
stack-member-number
standby-cpu
Command Default
Immediately reloads the stack member and puts a configuration change into effect.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
If there is more than one switch in the switch stack, and you enter the reload slot stack-member-number
command, you are not prompted to save the configuration.
Examples
This example shows how to reload the switch stack:
Controller# reload
System configuration has been modified. Save? [yes/no]: y
OL-32317-01
(Optional) Specifies to not verify the file signature before the reload.
(Optional) Verifies the file signature before the reload.
(Optional) Reason for the reload.
(Optional) Specifies the time in hh:mm for the reload to occur.
(Optional) Cancels the pending reload.
(Optional) Specifies a time interval for reloads to occur.
(Optional) Saves the changes on the specified stack member and then
restarts it.
(Optional) Reloads the standby route processor (RP).
Modification
This command was introduced.
High Availability Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
reload
21