Switch Renumber - Cisco WLC 5700 Series Command Reference Manual

switch renumber

switch renumber
To change the stack member number, use the switch renumber command in mode on the .
switch current-stack-member-number renumber new-stack-member-number
Syntax Description
current-stack-member-number
new-stack-member-number
Command Default
The default stack member number is 1.
Command Modes
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
If another stack member is already using the member number that you just specified, the assigns the lowest
available number when you reload the stack member.
If you change the number of a stack member, and no configuration is associated with the new stack member
Note
number, that stack member loses its current configuration and resets to its default configuration.
Do not use the switch current-stack-member-number renumber new-stack-member-number command on a
provisioned switch. If you do, the command is rejected.
Use the reload slot current stack member number privileged EXEC command to reload the stack member
and to apply this configuration change.
Examples This example shows how to change the member number of stack member 6 to 7:
High Availability Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
40
Modification
This command was introduced.
High Availability Commands
OL-32317-01