High Availability Commands
switch stack port
To disable or enable the specified stack port on the member, use the switch command in privileged EXEC
mode on a stack member.
switch stack-member-number stack port port-number {disable| enable}
Syntax Description
stack-member-number
stack port port-number
disable
enable
Command Default
The stack port is enabled.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.2SE
Usage Guidelines
A stack is in the full-ring state when all members are connected through the stack ports and are in the ready
state.
The stack is in the partial-ring state when the following occurs:
• All members are connected through their stack ports but some are not in the ready state.
• Some members are not connected through the stack ports.
Be careful when using the switch stack-member-number stack port port-number disable command. When
Note
you disable the stack port, the stack operates at half bandwidth.
If you enter the switch stack-member-number stack port port-number disable privileged EXEC command
and the stack is in the full-ring state, you can disable only one stack port. This message appears:
Enabling/disabling a stack port may cause undesired stack changes. Continue?[confirm]
OL-32317-01
Specifies the stack port on the member. The range is 1 to 2.
Disables the specified port.
Enables the specified port.
Modification
This command was introduced.
High Availability Command Reference, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
switch stack port
35