tams elektronik RailCom RCD-2 Manual page 37

RCD-2
Possible cause: The vehicle decoder in the supervised rail section
does not send a RailCom message, e.g. when in the corresponding
CV the RailCom function is set to off. à Check the vehicle decoder.

When a locomotive pulls into a connected track section the outputs
always switch, independant of the locomotive address.
Check the assignment of the outputs to the locomotive addresses.
Possibly a group of locomotive addresses has been programmed to a
regular assignment as well as to an inverted assignment. If you
cannot find the fault in programming, perform a reset.

Downstream loads are not switched as intended when particular
locomotives are pulling into the track section.
à Check the assignment of the outputs to the locomotive addresses.
If you cannot find the fault in programming, perform a reset.
à Check the switching times for the concerned outputs and alter
them, if necessary.
Hotline: If problems with your module occur, our hotline is pleased to
help you (mail address on the last page).
Repairs: You can send in a defective module for repair (address on the
last page). In case of guarantee the repair is free of charge for you.
With damages not covered by guarantee, the maximum fee for the
repair is the difference between the price for the ready-built module
and the kit according to our valid price list. We reserve the right to
reject the repairing of a module when the repair is impossible for
technical or economic reasons.
Please do not send in modules for repair charged to us. In case of
warranty we will reimburse the forwarding expenses up to the flat rate
we charge according to our valid price list for the delivery of the
product. With repairs not covered by guarantee you have to bear the
expenses for sending back and forth.
English
Page 37