tams elektronik RailCom RCD-2 Manual page 21

RCD-2
Fig. 2: PCB layout
Assembly
Proceed according to the order given in the list below. First solder the
components on the solder side of the PCB and then cut the excess
wires with the side cutter. Follow the instructions on soldering in
section 3.
Caution: Several components have to be mounted according to
!
their polarity. When soldering these components the wrong way
round, they can be damaged when you connect the power. In the
worst case the whole circuit can be damaged. At the best, a wrongly
connected part will not function.
English
Page 21