tams elektronik RailCom RCD-2 Manual page 33

RCD-2
Assigning further locomotive addresses to the detectors
In order to assign further locomotive address groups to the detectors
proceed as described in the section before.
Name of CVs
Detector 1
Detector 2
Detector 1
Detector 2
...
Detector 1
Detector 2
Allocating the outputs to the detectors and the locomotive
addresses
You allocate the 8 outputs of the RCD-2 to the two detectors and the
assigned locomotive address groups according to your needs. When a
locomotive from an assigned address group pulls into the connected rail
section, the allocated output will be switched. When inverting the
allocation the chosen outputs are switched when a locomotive not
belonging to the address group pulls into the section.
Determine the input values by adding the values corresponding to the
desired settings.
CV no.
50 to 53
60 to 63
70 to 73
80 to 83
...
270 to 273
280 to 283
Remarks and tips
locomotive address group 2
locomotive address group 2
locomotive address group 3
locomotive address group 3
...
locomotive address group 13
locomotive address group 13
English
Page 33