Configure Dante Device Settings - Extron electronics XMP 240 C AT Setup Manual

The software starts in Emulate mode.
3.
To create a configuration file offline and upload (push) that configuration to the XMP 240 C AT at a later time, remain in
a.
Emulate mode and save the configuration file.
To push a configuration to the XMP 240 C AT or pull the current configuration from the XMP 240 C AT, enter Live mode.
b.
When in Live mode, changes made in DSP Configurator affect the connected XMP 240 C AT immediately. To enter Live
mode, click Live at the top of the DSP Configurator workspace, select Tools > Connect to Device, or press <F6>
on the keyboard.
NOTE:
When Live mode is selected, a connection dialog box appears. Select the desired connection type and
follow the on-screen prompts (see the XMP 240 C AT User Guide for more information on connecting Live to a
device).
The main workspace provides access to mix matrices, gain blocks, and DSP processors for configuring the XMP 240 C AT. It also
provides a menu bar across the top with additional configuration tools. For more information about using DSP Configurator, see
the DSP Configurator Software section of the XMP 240 C AT User Guide or the DSP Configurator Help file that can be accessed
by selecting Help > Contents or pressing <F1> on the keyboard. Most dialog boxes within DSP Configurator contain a context
sensitive Help button (

Configure Dante Device Settings:

Dante settings on an XMP 240 C AT can be configured from DSP Configurator. The Dante device can be named here, which aids
in device identification in the Dante Controller software when there are multiple Dante devices on the audio network.
ATTENTION: It is essential that a Dante device be named before audio subscriptions with other devices are
established. Existing subscriptions are removed when a device is renamed.
To configure Dante device settings:
Open DSP Configurator and connect Live to the XMP 240 C AT (see step 3b above).
1.
Select Tools > Device Settings. The Device Settings dialog box opens.
2.
From the tabs at the top of the Device Settings dialog box, select Dante
3.
Device.
It may be necessary to use the right navigation arrow (
•
corner of the Device Settings dialog box to navigate to the Dante
Device tab (see figure to the right).
In the Device name field, give the XMP 240 C AT a meaningful name
4.
(such as device model and location) so that it can be easily identified in
Dante Controller.
Dante device network settings can also be configured from this dialog box.
5.
Use the radio buttons and text fields to choose DHCP (recommended) or
Static IP and enter a static IP address configuration.
NOTE:
The device name and IP configuration in the Dante Device tab
only affect the Dante interface of the XMP 240 C AT. These settings do
not affect the device name recognized in DSP Configurator or the IP
address of the rear panel LAN port.
Select Enable Redundant Mode only if configuring the XMP 240 C AT for
6.
use on redundant networks. A separate set of redundancy network settings opens for configuration (see
Physical Dante Network Setup in the XMP 240 C AT User Guide for more information on redundant configuration).
Click Apply.
7.
Click OK to confirm changes and close the Device Settings dialog box.
8.
For more information on configuring a XMP 240 C AT model in Dante Controller, refer to the Dante Controller section of the
XMP 240 C AT User Guide (www.extron.com).
) in the top right corner. Click this button to open the help file topic for that specific dialog box.
) at the top right
3