Tripp Lite B150-1A1-HDMI Owner's Manual page 4

Installation
3. Connect the RJ45 port on the transmitter to the RJ45 port on the
receiver using Cat5e/6 cable.
Note: See the installation diagrams for maximum extension distance at 1080p
and 1080i video resolutions.
4. Connect the receiver unit's built-in HDMI cable to an HDMI monitor
input port.
5. Connect the included USB Micro-B cable to the receiver unit and a USB
port on the display or USB wall outlet. The green LED on the receiver's
RJ45 port will illuminate to indicate it is receiving power from the USB
Micro-B cable.
6. Power on the DisplayPort source and HDMI display. The orange LED on
the receiver unit's RJ45 port will illuminate to indicate it is receiving a
signal from the source.
7. If necessary, use the Equalization control to adjust the video image.
Note: An improper Equalization setting can result in no image being displayed at
all. If an image is not displayed on your monitor, try adjusting the Equalization.
18-09-061-933883.indb 4
4
9/20/2018 9:26:55 AM