System Requirements; Installation - Tripp Lite B150-1A1-HDMI Owner's Manual

System Requirements

• Computer with a DisplayPort output port*
• Display with an HDMI input port
*Audio support requires a DisplayPort source that is enabled to support audio.

Installation

Notes:
1. Test to make sure the entire installation works properly before pulling cables through
ceilings/walls.
2. To achieve maximum distance and performance, 24 AWG solid-wire Cat5e/6 cable
must be used. The use of stranded-wire Cat5e/6 cable or cable with a gauge size
higher than 24 AWG will result in a shorter extension distance. All Tripp Lite N202-
Series Cat6 cables are made with 24 AWG solid-wire cabling.
3. Make sure the power to all connected devices is turned off prior to installation.
DISPLAYPORT
COMPUTER
1. Connect the transmitter unit's built-in DisplayPort cable to the
computer's DisplayPort output port.
2. Connect the included USB Micro-B cable to the transmitter unit and a
USB port on the computer or USB wall outlet. The green and orange
LEDs on the transmitter unit's RJ45 ports will illuminate to indicate it is
receiving power from the USB Micro-B cable.
18-09-061-933883.indb 3
2
24 AWG SOLID-WIRE
1
3
Cat5e/6 CABLE
Up to 125 ft. at 1080p
Up to 150 ft. at 1080i
3
5
4
HDMI DISPLAY
9/20/2018 9:26:55 AM