Battery Storage; Power Package Recommissioning - Mercury Inboard 5.7L Manual

Storage
d.
3. On models with a seawater pickup pump, remove the two blue drain plugs. If the
seawater pickup pump does not have blue drain plugs, or you are unable to access
them, loosen the clamps and remove both hoses.
4. Crank the engine over slightly with starter motor to purge any water trapped in the
seawater pickup pump. Do not allow the engine to start.
5. After the cooling system has been drained completely, install the drain plugs, reconnect
hoses, and tighten all hose clamps securely.

Battery Storage

Whenever the battery will be stored for an extended period of time, be sure the cells are
full of water and the battery is fully charged and in good operating condition. It should be
clean and free of leaks. Follow the battery manufacturer's instructions for storage.

Power Package Recommissioning

1. Ensure that all cooling system hoses are connected properly and hose clamps are tight.
Avoid electrical system damage. When installing the battery, be sure to connect the
negative (‑) battery cable to the negative (‑) battery terminal and the positive (+) battery
cable to the positive (+) battery terminal.
2. Install a fully charged battery. Clean the battery cable clamps and terminals and
reconnect cables. Tighten each cable clamp securely when connecting.
Page 64
Check valve
a
a - Drain plug (if equipped)
b
a - Hose clamps
6131
a
b - Blue drain plugs
CAUTION
!
6145
90-860174050 JUNE 2005