Mounting Instructions - CDVI DGLP WLC Installation Manual

INSTALLATION MANUAL
DGLP WLC - DGLP FN WLC - DGLPM WLC - DGLI WLC - DGLI F WLC
Proximity Card Readers - Wiegand Output

7] MOUNTING INSTRUCTIONS

Make sure that there are no pieces missing in the mounting kit. Get the right tools according to the installation
type (Drill, screw drivers, metre tape,...) and follow the mounting instructions of the reader.
Ref : DGLP WLC, DGLPM WLC and DGLI WLC
1
Measure and mark the
center lines to determine
the reader position. Drill
the fixing screw holes
(Diametre: 4MM for the
mounting plate and 6MM
for the reader). Drill the
wiring access area.
Ref : DGLP FN WLC and DGLI F WLC
1
(x2)
(x2)
Measure and mark
the center lines to de-
termine the reader
position. Drill the fixing
screw holes (Diametre:
4MM for the mounting
plate and 6MM for the
reader). Drill the wiring
access area.
2
(x2)
(x2)
(x2)
(x2)
DGLI WLC
Insert the brass an-
chors in the mounting
holes, connect the cable
to the terminal block,
then fasten the reader
with the DIAX screws
®
using the DIAX span-
®
ner. Make sure that the
varistor is connected on
the lock (refer to page 2
«Recommendations»).
2
(x2)
(x2)
(x2)
(x2) (x2)
(x2)
(x2)
DGLI F WLC
Insert the brass an-
chors in the mounting
holes, connect the
cable to the connectors,
then fasten the reader
with the DIAX screws
®
using the DIAX span-
®
ner. Make sure that the
varistor is connected on
the lock (refer to page 2
«Recommendations»).
3
(x2)
(x2)
(x2)
(x2) (x2)
DGLP WLC et DGLPM WLC
Insert the plastic an-
chors in the mounting
holes, connect the
cable to the terminal
block, Then fasten the
reader with the wooden
screws Leave an area
to access the cable to
make the wiring). Put the
covers on top of the reader.
Make sure that the va-
ristor is connected on
the lock (refer to page 2
«Recommendations»).
3
(x2)
(x2)
(x2)
(x2)
(x2)
DGLP FN WLC
Insert the plastic an-
chors in the mounting
holes, connect the
cable to the terminal
block, then fasten the
reader with the wooden
screws. Put the covers
on top of the reader.
Make sure that the
varistor is connected on
the lock (refer to page 2
«Recommendations»).
(x2)
(x2) (x2)
(x2)
4
(x2)
(x2)
(x2)
(x2)
Optional (MPLATE)
Single gang box moun-
ting plate for the
DGLP FN WLC mullion
polycarbonate proximity
card reader.
cdvi.com
7
cdvigroup.com