Download  Print this page

Installation Requirements; Tools And Parts; Location Requirements - Whirlpool W10115226B Installation Instructions Manual

27" wide models - u.s.a. only
Hide thumbs

Advertisement

Table of Contents

Tools and Parts

Gather the required tools and parts before starting
installation. Read and follow the instructions provided
with any tools listed here.
Tools needed:
Flat-blade screwdriver
Wire stripper
(direct wire installations)
1/4" nut driver
(recommended)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Tape measure
Level
Putty knife

InSTAllATIon REquIREmEnTS

#2 Phillips screwdriver
Tin snips
(new vent installations)
Vent clamps
Utility knife
Pliers
Caulking gun and
compound (for installing
new exhaust vent)
Parts supplied:
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed:
Check local codes. Check existing electrical supply and venting,
and read "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Mobile home installations require metal exhaust system
hardware, available for purchase from the dealer from whom
you purchased your dryer. For further information, please
reference the "Assistance or Service" section of the "Dryer
User Instructions."
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL listed 30-amp power supply cord, rated 120/240 volt
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to the
dryer must end in ring terminals or spade terminals with
upturned ends.
A UL listed strain relief.

location Requirements

You will need:
A location allowing for proper exhaust installation.
See "Venting Requirements."
A separate 30 amp circuit.
3

Advertisement

Table of Contents
loading

  Related Manuals for Whirlpool W10115226B

This manual is also suitable for:

W10115227b-spMedx700xlMedx700xw